brewhardware

Recirculating wort back into the kettle to whirlpool the wort makes for much faster cooling and will also make a concentrated pile of trub and hop particles in the center of the kettle bottom. This whirlpool port assembly installs high up on your kettle...

Brewers that use immersion chillers and also own a pump should know that recirculating the wort back into the kettle to whirlpool the wort makes for much faster cooling and will also make a concentrated pile of trub and hop particles in the center...

Type A - Male QD/ Female 1/2" NPT. The most common use for this part is attaching to the wort in/out ports on a plate chiller. It can also be used for recirculation ports, the in/out of a HERMS coil. etc. Brewhardware's stainless steel...

Type B - Female QD Coupling to Male 1/2" NPT. These are usually installed on the more portable or "mobile" end. The type B can be coupled to a garden hose adapter to backflush plate chillers or to fill vessels with fresh brewing water....

Brewhadware's stainless steel Camlock style disconnects (sometimes called cam and groove) are a great compromise between cost and function for connections between vessels, chillers, pumps and hose sets. The "quick disconnect" portion of the camlock system consists of male and female parts. The male...

Type F - Male QD/ Male 1/2" NPT. The most common use for this part is attaching to the output of your vessel ball valves. Brewhardware's stainless steel Camlock style disconnects (sometimes called cam and groove) are a great compromise between cost and function...

This high flow elbow barb is used with the Type B camlock (purchased separately) This is great for the hose ends that connect to vessel bulkheads. When three or four feet of silicone gets filled with liquid, it tends to pull down and kink...

1-1/2" Tri-Clamp (TC) Tee.

1.5" Tri-Clamp (TC) flange to 1/2 " FNPT. Adapts 1/2" NPT Male fittings to 1.5" Tri-Clamp.

1-1/2" Triclover (TC) flange to 1/4" OD hose barb. This is best for use with 3/16" or 1/4" ID tubing such as our Bevlex tubing.

1-1/2" Tri-Clamp (TC) flange to 1/4" MFL (Male Flare Adapter). Good for connecting a swivel barb adapter or gas connection to a chilling manifold.

1-1/2" Tri-Clamp (TC) flange to 5/8" OD hose barb. This is best for use with 1/2" ID silicone tubing to ensure maximum flow.

This allows you to snap on a ball-lock liquid disconnect on to a 1.5" TC port. The ball lock post is removable from the TC side and it is equipped with a poppit valve like all corny posts.

Adapt any 2" tri-clamp port or valve to work with an existing 1.5" tri-clamp fitting. The eccentric design is ideal for reducing 2" to 1.5" pipe in horizontal runs. Perfect for attaching a 1.5" hose to the bottom of fermenters with 2" bottom ports. 1.5"...

2" Tri-Clamp (TC) flange to 1/2 " FNPT. Adapts 1/2" NPT Male fittings to 2" Tri-Clamp.